User manual

AV2USB
Page 17 of 24
Copyrights DSP4YOU ltd
4.1 User interface overview of the AVB Streamer toolbox
AV2USB configuration software provides a simple user interface for configuration of the AVB
 A Device tree on the left side lists all discovered AVB devices on the network
 A center section tabbed based structure allows access to the various sections of the user interface
Tabbed Structure
 Device info: Provides overall view of the current settings of AV2USB device including the model number,
firmware version, IP settings.
 Audio settings: Digital Signal Processing section of the interface. Provides control to the basic gain control
and advanced DSP algorithms running on the on board Digital Signal Processor. Note that the digital signal
processing section will only be enabled if this feature was purchased.
4.2 AV2USB Stream configuration
4.2.1 Device info page
AVB end points are automatically discovered and listed as part of the AVB tree. Once your PC connected to the
network, simply open the AVB Streamer toolbox to have access to all settings.
To access the settings of a specific device, click on the AVB device tree on the left. The device info page will
automatically load the settings for this device. See below an example.
4.2.1.1 Rename device
By default, AVB endpoints will carry the name of the MAC Address of the network interface. The default name can
however be modified to a more meaningful “hostname”.
To change the name of the device, simply type a new name in the text window and click on the SET button.
The renaming is instantaneous and the device will appear in the tree with its new name.