User manual

69
Programs
TPS400-5.0.1en
The following entries are possible:
Offset+: Parallel offset of the reference line
to the right, referred to the direction
of the base line (BP1-BP2).
Line+: Longitudinal offset of the start point
(=reference point) of the reference
line in the direction of base point BP2.
Rotate+: Rotation of the reference line clock-
wise around the reference point.
Height+: Height offset; the reference line is
higher than the selected reference
height.
3. Selecting the subapplication
[MEASURE] Starts the subapplication to measure
Line & Offset (see issue 4).
[STAKE] Starts the subapplication to stake
out (see issue 5).
4. "Line & Offset" subapplication
The "Line & Offset" subapplication calculates from
measurements or coordinates longitudinal, parallel
offsets and height differences of the target point
relative to the reference line.
NewBL MEASURE STAKE SHIFT=0
REFERENCE LINE - MAIN 1/2
Length : 14.872 m
Enter values to shift line:
Offset : 1.000 m
Line : 0.500 m
Height : 0.900 m
Rotate : 25.0000 g