User manual

64
Programs
TPS400-5.0.1en
)
If the instrument height was set to 0.000 in
the setup screen, then the station height refers to
height of trunnion axis.
Displays standard deviations:
Std.Dev E0, N0, H0 Standard deviation of the
station coordinates
Std.Dev Ang Standard deviation of the orien-
tation
This dialog shows the computed residuals:
Residual = Calculated value - Measured value
[PREV] Switches to measurement display,
to measure additional points.
[Re-Meas] Remeasures the displayed point.
[OK] Always sets the displayed coordi-
nates and instrument height as new
station.
PREV OK
STATION STANDARD-DEVITION
Std.Dev.EO : 0.027
Std.Dev.NO : 0.013
Std.Dev.HO : 0.000
Std.Dev.Ang: +0.0121
PREV Re-Meas OK
TARGET RESIDUALS 3/3
PtID : 300
Hz : -0.0096 g
: -0.019 g
: 0.001 g