User manual

FNC Key

TPS400-5.0.1en

Procedure:

1. Enter the offset values (length, cross and/or

height) as per the sketch.

2. Define the period for which the offset is to be

applied.

[RESET]: Sets eccentricity to zero.

3. [SET]: calculates the corrected values and

jumps to the application from which the offset

function was started. The corrected angle and

distances are displayed as soon as a valid

distance measurement has been triggered or

exists.

The period of applicability can be set as follows:

)

The offset values are always reset to 0 when

the application is quit.

Cylinder Offset subapplication

Use [CYLNDER] to determine the coordinates of the

centre point of cylindrical objects and their radius.

Measure the horizontal angle to a point on the left

and on the right side of the object as well as the

distance to the object.

RESET CYLNDER OK

Trav. Offset: 0.600 m

Length Offset: 0.800 m

Height Offset: 0.500 m

Mode : Reset after REC

Enter offset values!

Reset after REC

The offset values are reset to 0

after the point is saved.

Permanent

The offset values are applied to all

further measurements.