User manual

Measuring Preparation /

Setting up

TPS400-5.0.1en

Setup step-by-step

1. Extend the tripod legs to allow for a comfortable

working posture. Position the tripod over the

marked ground point, centring it as well as

possible.

2. Fasten the tribrach and instrument onto the

tripod.

3. Turn on the instrument and switch on the laser

plummet and electronic level by pressing [FNC]

> [Level/Plummet].

4. Move the tripod legs (1) and use the tribrach

footscrews (6) to centre the plummet (4) over

the ground point.

5. Adjust the tripod legs to level the circular level

(7).

6. By using the electronic level turn the tribrach

footscrews (6) to precisely level the instrument.

)

Refer to "Levelling up with the electronic

level step-by-step" for more information.

7. Centre the instrument precisely over the ground

point (4) by shifting the tribrach on the tripod

plate (2).

8. Repeat steps 6. and 7. until the required accu-

racy is achieved.