User manual

112
Data Transfer
TPS400-5.0.1en
Data Transfer
With this special function measured data can be trans-
ferred via the serial interface to a receiver (e.g. a
Laptop). Using this type of transfer the success of the
transfer is not checked.
Job: Selection of job from which data should
be transferred.
Data: Select the data range to be transferred
(measurements, fixed points)
Format: Select output format. Select Leica-GSI-
format, or your own format created in
the "Format Manager" and transfer to
the LGO/LGO-Tools.
[SEND] Starts the transmission.
Example:
Within the "data" setting "MEASUREMENTS" a data
set could be shown as follows:
11....+00000D19 21..022+16641826
22..022+09635023 31..00+00006649
58..16+00000344 81..00+00003342
82..00-00005736 83..00+00000091
87..10+00001700
)
If the receiver is to slow in processing data
the data could be lost. With this type of data transfer
the instrument is not informed about the perfor-
mance of the receiver (no protocol).
GSI-ID’s
11 PtID
21 Horizontal direction
22 Vertical angle
25 Orientation
31 Slope distance
32 Horizontal distance
33 Height difference
41-49 Codes and attributes
51 ppm [mm]
58 Prism constants
81-83 (E, N, H) Target point
84-86 (E, N, H) Stand point
87 Reflector height
88 Instrument height