User guide

UG-564 Evaluation Board User Guide
Rev. 0 | Page 4 of 32
Figure 4. ADAU196xA I
2
C Control, Address 00
The Automated Register Window Builder controls the
ADAU196xA and is available for download at
www.analog.com/ADAU1962A or www.analog.com/
ADAU1966A.
The ADAU196xA can also be put in SPI mode for control by
other means. See Figure 5 for the correct jumper positions.
Figure 5. ADAU196xA SPI Control
AUTOMATED REGISTER WINDOW BUILDER
SOFTWARE INSTALLATION
The Automated Register Window Builder is a program that
launches a graphical interface for direct, live control of the
ADAU196xA registers. The GUI content for a specific part is
defined in a part-specific .xml file; these files are included in the
software installation.
To install the Automated Register Window Builder software,
follow these steps:
1. Go to www.analog.com/ADAU1962A or
www.analog.com/ADAU1966A and download the
ARWBvXX.zip file from the product page.
2. Open the downloaded ARWBvXX.zip file and extract the
files to an empty folder on your PC.
3. Install the Automated Register Window Builder by double-
clicking setup.exe and following the prompts. A computer
restart is not required.
4. Copy the .xml file for the ADAU196xA from the extraction
folder into the folder C:\ProgramFiles\Analog Devices
Inc\AutomatedRegWin, if it is not already installed.
HARDWARE SETUP—USBi
To set up the USBi hardware, follow these steps:
1. Plug the USBi ribbon cable into the J12 I
2
C/SPI port.
2. Connect the USB cable to your computer and to the USBi.
3. When prompted for drivers,
a. Choose Install from a list or a specific location.
b. Choose Search for the best driver in these locations.
c. Check the box for Include this location in the search.
d. Find the USBi driver C:\Program Files\Analog
Devices Inc\AutomatedRegWin\USB drivers.
e. Click Next.
f. If prompted to choose a driver, select CyUSB.sys.
g. If the PC is running Windows® XP and a message
appears stating that the software has not passed
Windows logo testing, click Continue Anyway.
You can now open the Automated Register Window Builder
application and load the .xml file for the part on your
evaluation board. Plug the 10-way ribbon cable on the USBi
into the I
2
C/SPI port (J12) on the evaluation board.
1
1588-004
1
1588-005