Data Sheet

FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
If the FCC identification number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following:
“Contains Transmitter Module FCC ID: 2AYEN-DHANT Or Contains FCC ID: 2AYEN-DHANT”
When the module is installed inside another device, the user manual of the host must contain
below warning statements;
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer's instructions
as described in the user documentation that comes with the product.
Any company of the host device which install this modular with Single modular approval should
perform the test of radiated emission and spurious emission according to Title 47 of the CFR,
Part 15 Subpart D requirement, Only if the test result comply with Title 47 of the CFR, Part 15
Subpart D requirement，then the host can be sold legally.
General Statements
(1)Module use PCB antenna, the maximum gain is 0dBi.
(2)Any change of antenna type is not allowed,module only use PCB antenna.
(3)Host containing modules must comply with FCC Rule requirements.
RF Exposure
This equipment complies with radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with Maximum distance 20 cm between the radiator
and your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux radiations dans un environnement non
controlé. Cet équipement doit être installé et utilisé à distance minimum de 20 cm entre le
radiateur et votre corps. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction
avec tout autre antenne ou transmetteur.”