Installation Guide
Installation (continued)
6
□
□
□
Cutting the xture wire
4
Conrm the desired hanging height. Refer to step 3 if adjustments are needed.
Using wire cutters, cut the xture wire leaving approximately 10 inches of wire extending from the Canopy. On the xture wire,
remove 4 inches of the outer sleeve.
Using wire strippers, strip each wire ½ inch from the end.
Ceiling canopy
Fixture wire
□
□
5
Making the electrical connections
Green ground screw
* Use wire connectors (CC) to connect the wires.
Ground wire:
1. Wrap the supply ground wire around the green ground screw
on the crossbar, no less than 2 in. from the end of the wire.
Tighten the ground screw.
2. Connect the xture ground wire to the supply ground wire
with a wire connector (CC).
Supply wire:
1. Connect the supply white wire to the white xture supply
wire with a wire connector (CC).
2. Connect the supply black (or red) wire to the black xture
supply wire with a wire connector (CC).
3. Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the outlet box.
AA
CC