Installation Guide

7
EE
DD
9
Making the electrical connections
□
□
* Use wire connectors (CC) to connect the wires.
Ground wire:
1. Wrap supply ground wire around green ground screw on
mounting bracket, no less than 2 in. from the end of the wire.
Tighten ground screw.
2. Connect xture ground wire to supply ground wire with
wire connector (CC).
Supply wire:
1. Connect the house white wire to the xture supply wire
(ribbed sided) from xture identied with the label “N”.
2. Connect the house black (or red) wire to the xture supply
wire (smooth side) from xture identied with the label “L”.
3. Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the outlet box.
□
Push the xture wire
7
Push the ends of the supply wires and ground wire up
through the canopy chain loop and into the outlet box. The
remaining slack wire will be pushed into the box in STEP 8.
□
□
□
□
□
□
Trim excess xture wire
8
Unthread the canopy lock ring.
Slide canopy lock ring and ceiling canopy (EE) down the
quick link (DD).
Push all slack xture wire through canopy chain loop and
into the outlet box.
Trim excess xture wire leaving a minimum of 6 inches
hanging out of the outlet box.
Separate the smooth side and ribbed side of the supply wire
to about 3 inches from the end.
Using wire strippers, strip each wire ½ inch from the end.
Installation (continued)
Supply wire
and ground wire
Canopy lock ring
Supply wire
and ground wire
CC
Ground wire
from supply
Ground wire from xture identied
with the label “G”
Green ground screw
Black (or red)
wire from supply
Ribbed side of wire from
xture identied with the
label “N”
Smooth side of wire from
xture identied with the label “L”
White wire from supply