Installation Guide
Installation (continued)
6
DD
AA
NOTE: To make the next step easier, cut the supply
wire and ground wire 24 inches from the xture loop.
□
□
□
Installing the xture loop
4
Pass supply wires and ground wire through the xture loop (A).
Then thread the xture loop (A) to the uppermost rod.
Hand- tighten until snug.
5
Test tting ceiling canopy to crossbar
assembly
AA
EE
□
□
□
NOTE: If the ceiling canopy is not snug against the ceiling,
remove it from the crossbar assembly and adjust the length
of the pre-assembled nipple by unscrewing the
pre-assembled hex nut.
Screw the nipple in or out of the crossbar until the correct
length is achieved. Then, re-attach the ceiling canopy.
Remove the pre-assembled canopy lock ring from the
crossbar assembly (AA).
Temporarily attach the ceiling canopy (EE) to the
pre-assembled nipple on the crossbar assembly (AA).
Secure with canopy lock ring.
Canopy lock ring
Rod
A
A
□
□
Assembling the xture body to the outlet box
6
Connect the xture loop (A) to the xture chain pre-assembled to crossbar assembly (AA) using the quick link (DD).
Conrm that the mounting height is acceptable. Refer to STEP 3 if changes are required.
Fixture chain