Installation Guide
Installation
5
□
Installing the crossbar assembly
AA
BB
2
Secure the crossbar assembly (AA) to the outlet box (not
included) with outlet box screws (BB). Tighten until snug.
NOTE: The preassembled mounting nipple on the
crossbar should protrude outward.
NOTE: Please pay attention to the polarity (wires labels
L & N) when remove wires labels. Wire identication will
be needed in STEP 9.
□
□
□
□
□
□
Assembling the rods to the xture body
3
Remove wires labels from the supply wires and the ground wire.
Choose desired hanging length for the light xture.
Assemble the necessary rods using the 6 in. rod(s) and/or 12 inch rod(s).
Pass supply wires and ground wires through the rod assembly.
Attach the rod assembly to xture. Hand- tighten until snug.
Then thread the xture loop (A) to the uppermost rod. Hand- tighten until snug.
Hint:
- Assemble one rod at a time.
- Pass the ground wire through the rod rst.
- Then, pass the supply wire through the rod.
- Thread the rod by hand until snug.
Suggested rod length to hang xture 30 inches above
an island top:
- 8 ft. ceiling (1) 12 in. rods
- 9 ft. ceiling (2) 12 in. rods
- 10 ft. ceiling (3) 12 in. rods
A
B
C
□
□
□
1
FF
D
E
F
G
Thread the bridge (D), the center column (E) and the socket
assembly (F) as shown. Tighten until snug.
Conrm that the holes on the bridge (D) align with the mounting
holes on the cage (G). Pass mounting screws (FF) through hole of
the cage (G) and thread into the mounting holes on the cage (G).
Do not fully tighten at this step.
Fully tighten each mounting screw (FF) after complete assembly.