Instructions / Assembly

Installation (continued)
B
JJ
HH
HH
CC
A
II
C
F
E
D
H
I
B
C
6
Ƒ Hook one end of the 12 wood bead strand (E) onto the hole of
the cap of top of the xture body (D) and the other end onto
the hook of top of the frame of the xture body (D) as shown
on the diagram.
Ƒ Repeat this step on the remaining 12 wood bead strands.
Ƒ Hook one end of the 27 wood bead strand (F) onto the hook of
bottom of the frame of the xture body (D) and the other end
onto the hole of the cap (H) as shown on the diagram.
Ƒ Repeat this step on the remaining 27 wood bead strands, and
tighten the nial (I).
Ƒ Adjust the chain (B) to the desired height by spreading the
end link of the chain (B) apart. Use a pair of pliers and a
screwdriver. Wrap a soft cloth around the pliers to protect the
chain’s nish.
Ƒ Open the rst quick link (JJ), connect chain (B) to the loop (C)
and close the quick link (JJ).
Ƒ Open the second quick link (JJ), connect other end of chain
(B) to the screw collar loop (HH) and close the quick link (JJ).
6
Attaching the chain
7
Weaving the xture wire
Ƒ Unscrew the ring (II) from the screw collar loop (HH), and
lower the canopy (A) and ring (II) over the chain (B) on the
xture.
Ƒ Weave the xture wires and bare copper ground wire up
through the chain (B), ring (II), canopy (A), screw collar loop
(HH), threaded tube (CC), and then into the outlet box.
5
Hook the wood strands