Instructions / Assembly

Installation
AA
AA
BB
CC
DD
HH
II
EE
A
C
J
K
G
H
I
D
CC
5
Ƒ Screw the threaded tube (CC) into the mounting strip (AA), and
secure it using the lock washer (EE) and hex nut (DD).
Ƒ Fasten the mounting strip (AA) onto the outlet box using two
outlet box screws (BB).
Ƒ Place the canopy (A) over the threaded tube (CC), and screw
the screw collar loop (HH) onto the threaded tube (CC).
Ƒ Secure the canopy (A) using the ring (II).
Ƒ Guide the xture wire with bare copper ground wire through the
tube (J), xture body (D), and loop (C), then tighten the xture
body (D) and the tube (J) together on the socket assembly (K)
until secured respectively as shown in the diagram, and tighten
the loop (C) onto the top of the xture body (D).
Ƒ Fasten the threaded tube (G) into the bottom of the socket
assembly (K) as shown. Place the cap (H) over the threaded
tube (G) and secure by the nial (I) and do not lock too tight.
1
Preparing the mounting strip
3
Attaching the canopy to the outlet
box
4
Assembling the xture body
2
Installing the mounting strip
NOTE: The threaded tube (CC) should extend long
enough to protrude through the canopy, when it is
mounted. (Adjust as needed.)