Instructions / Assembly

IMPORTANT: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have occurred
during shipping. If there is a defect in the wire, do not
attempt installation. Please call the Customer Service
Team at 1-800-388-6141 ext. 216. For customer service
support and the fastest response, please email us at
[e-mail].
NOTE: This product requires five 60W maximum
candelabra base (E12) type "B" bulbs or 9W maximum
candelabra base (E12) self-ballasted LED bulbs (sold
separately).
Pre-Installation
NOTE: Hardware not shown to actual size.
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard.
Phillips
Screwdriver
Safety
Goggles
Wire
Stripper
Electrical
Tape
Pliers
TOOLS REQUIRED (NOT INCLUDED)
HARDWARE INCLUDED
AA
BB CC
DD
3
Part Description Quantity
AA
Mounting strip
1
BB
Outlet box screw
2
CC
Threaded tube
1
DD
Hex nut
1
EE
Lock washer
1
Part Description Quantity
FF
Green ground screw
(Pre-assembled to mounting strip (AA))
1
GG Wire connector 3
HH Screw collar loop 1
II
Ring
(Pre-assembled to screw collar loop (HH))
1
JJ Quick link 2
FF
EE
GG HH
II JJ