Item # 305 202 729 Model # DS18113 USE AND CARE GUIDE 1-LIGHT WALL SCONCE Questions, problems, missing parts? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Five (5) Year Warranty ............................................................... 2 What is Covered ........................................................................ 2 What is Not Covered ..................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping. If there is a defect in the wire, do not attempt installation. Please call the Customer Service Team at 1-800-388-6141 ext. 216.
Pre-Installation (continued) PACKAGE CONTENTS A B C D Part Description Quantity A Fixture body 1 B Rubber washer 3 C Thumbscrew 3 D Glass shade 1 4
Installation 1 2 Preparing the mounting bracket □□ Fasten the support screws (long) (CC) into the mounting bracket (AA), and secure it using the hex nuts (DD). Installing the mounting bracket □□ Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (short) (BB). NOTE: The support screws (long) (CC) should extend long enough to protrude through the canopy on the fixture body (A) when it is mounted. (Adjust as needed.
Installation (continued) 4 5 Assembling the fixture body to the outlet box □□ Place the glass shade (D) over the socket, align the holes of the glass shade (D) with the holes of the cap of the fixture body (A), then secure the glass shade with the rubber washers (B) and the thumbscrews (C) as shown on the diagram. □□ Place the fixture body (A) over the outlet box, and ensure the heads of the support screws (long) (CC) come through the holes of the canopy of the fixture body (A).
Care and Cleaning □□ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully. □□ To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture. Troubleshooting Problem Possible Cause Solution The lights will not turn on. The bulb is burned out. The power is off. There is a faulty switch.
Service Parts MODEL: DS18113 DD Part Description AA Mounting bracket BB Outlet box screw (short) CC Support screw (long) DD Hex nut EE Green ground screw FF Wire connector GG Cap nut A Fixture body B Rubber washer C Thumbscrew D Glass shade AA BB CC EE FF GG A (Pre-assembled to mounting bracket (AA)) B C D 8
Questions, problems, missing parts? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.