Instructions / Assembly
Installation (continued)
6
NOTE: You may need to use pliers (not included) to open
the links of the xture chain (FF). If so, put a cloth over the
xture chain (FF) to protect the nish from the pliers.
□
□
□
□
□
Installing the xture chain
3
Guide the xture wire with bare copper ground wire through the xture loop assembly
(A), and screw the xture loop (A) onto the top of the xture body (B) securely.
Choose desired hanging length for the light xture. Suggested mounting height over a
table or island is 30 inches from the table/island top to the bottom of the xture.
Adjust the xture chain (FF) to the desired length, removing links if necessary.
Connect one end of the xture chain (FF) to the canopy chain loop preassembled to
the crossbar assembly (AA) with one quick link (DD).
Connect the other end of the xture chain (FF) to the xture loop assembly (A) with the
remaining quick link (DD).
Suggested chain length to hang xture 30 inches above
table top:
8-ft. ceiling: 10 in. of chain + 2 quick links
9-ft. ceiling: 22 in. of chain + 2 quick links
10-ft. ceiling: 34 in. of chain + 2 quick links
11-ft. ceiling: 46 in. of chain + 2 quick links
12-ft. ceiling: 58 in. of chain + 2 quick links
4
Pulling the supply wires
□
□
Pull the supply wires and ground wire up through the xture
chain alternating links.
Push the ends of the supply wires and ground wire up through
the canopy chain loop and into the outlet box. The remaining
slack wire will be inserted into the outlet box in STEP 6.
NOTE: To make the next step easier, cut the supply wire
and ground wire 24 inches longer than the distance from
the xture loop to the ceiling. Important: Please pay
attention to the polarity (wires labels L & N) when cutting
wires. Wire identication will be needed in STEP 5.
Supply Wire
and Ground Wire
Canopy chain loop
DD
AA
DD
A
FF
B