Instructions / Assembly

Installation

□

Installing the crossbar assembly

Secure the crossbar assembly (AA) to the outlet box (not included) with the outlet box screws (BB). Tighten until snug.

NOTE: The preassembled mounting nipple on the

crossbar should protrude outward.

□

NOTE: If the ceiling canopy is not snug against the ceiling, remove it from the crossbar assembly and adjust the length of the

pre-assembled nipple by unscrewing the pre-assembled hex nut.

Screw the nipple in or out of the crossbar until the correct length is achieved. Then, re-attach the ceiling canopy.

Remove the pre-assembled canopy lock ring from the crossbar assembly (AA).

Temporarily attach the ceiling canopy (EE) to the pre-assembled nipple on the crossbar assembly (AA).

Secure with the canopy lock ring (1).

Test tting the ceiling canopy to the crossbar assembly