Instructions / Assembly

Installation (continued)
6
A
B
B
C
C
C
D
E
Installing the rods and the ceiling canopy
3
□
□
4
Making the electrical connections
* Use wire connectors (CC) to connect the wires.
Ground wire:
1. Wrap the supply ground wire around the green ground screw
on the crossbar assembly (AA), no less than 2 in. from the end
of the wire. Tighten the ground screw.
2. Connect the xture ground wire to the supply ground wire
with a wire connector (CC).
Supply wire:
1. Connect the supply white wire to the white xture supply
wire with a wire connector (CC).
2. Connect the supply black (or red) wire to the black xture
supply wire with a wire connector (CC).
3. Wrap each connection with approved electrical tape and
carefully insert all of the connected wires into the outlet box.
Green ground screw
□
□
□
□
□
□
Guide the xture wire with bare copper ground wire through the decorative part (D),
and screw the decorative part (D) onto the top of the socket assembly (E) securely.
Choose desired hanging length for the light xture.
Assemble the rods (B/C) to the desired length.
Pass the supply wires and the ground wires through the rod assembly.
Attach the rod assembly to the decorative part (D), hand-tighten until snug.
Thread the ceiling canopy (A) to the uppermost rod. Hand-tighten until snug.
Hint:
- Assemble one rod at a time.
- Pass the ground wire through the rod rst.
- Then, pass the supply wire through the rod.
- Thread the rod by hand until snug.
Suggested rod length to hang xture 30 inches above table top:
- 8 ft. ceiling (2) 6 in. rods + (1) 12 in. rods
- 9 ft. ceiling (2) 6 in. rods + (2) 12 in. rods
- 10 ft. ceiling (2) 6 in. rods + (3) 12 in. rods
CC
AA
CC