Instructions / Assembly

Installation

□

Test tting the ceiling canopy to the crossbar assembly

Installing the crossbar assembly

□

Remove the mounting balls (1) from the crossbar assembly (AA).

Fit the ceiling canopy (A) to the crossbar assembly (AA) and secure with the mounting balls (1).

*If they do not align, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled hex nuts.

*Then, screw the mounting screws in or out of the crossbar until the desired length is achieved.

*Once the ceiling canopy (A) is secure, remove the mounting balls (1) and the ceiling canopy (A) and proceed to Step 3.

Secure the crossbar assembly (AA) to the outlet box (not included) with the outlet box screws (BB). Tighten until snug.

NOTE: The preassembled mounting screws on the

crossbar should protrude outward.

NOTE: The ceiling canopy (A) should be snug against

the ceiling and the mounting balls (1).