Instructions / Assembly

Installation (continued)
6
□
□
□
□
5
B
A
Installing the shade and the light bulb
Remove the socket collar from the socket on the xture
body (A).
Then place the shade (B) over the socket on the xture body
(A) as shown.
Secure by threading the socket collar onto the socket.
Hand-tighten until snug.
Install the correct bulbs (not included) referring to xture
markings and/or labels for maximum wattage.
socket collar
A
Mounting balls
AA
□
□
3
Making the electrical connections
AA
CC
Green ground screw
□
□
4
Installing the xture body to outlet box
Re-attach the backplate on the xture body (A) to the
crossbar assembly (AA).
Secure with the previously removed mounting balls.
NOTE: Use (3) 100W maximum medium base (E26) type "A"
or 15W maximum medium base (E26) self-ballasted LED bulbs
(sold separately).
* Use wire connectors (CC) (supplied) to connect the wires.
Ground Wire:
1. Wrap the supply ground wire around the green ground screw on the crossbar assembly (AA), no less than 2 in. from the end of the
wire. Tighten the ground screw.
2. Connect the xture ground wire to the supply ground wire with a wire connector (CC).
Supply Wire:
1. Connect the supply white wire to the white xture supply wire with a wire connector (CC).
2. Connect the supply black (or red) wire to the black xture supply wire with a wire connector (CC).
3. Wrap each connection with approved electrical tape and carefully insert all of the connected wires into the outlet box.