Instructions / Assembly

Installation

□

Installing the crossbar assembly

Secure the crossbar assembly (AA) to the outlet box (not included) with the outlet box screws (BB). Tighten until snug.

NOTE: The preassembled mounting screws on the crossbar should protrude

outward.

NOTE: The backplate on the xture body (A) should be snug against the ceiling

and the mounting balls.

NOTE: Prior to installation, close or cover the sink drain and/or any vents near the

installation site to prevent loss of mounting hardware if dropped.

Test tting backplate on the xture body to the crossbar assembly

□

Remove the mounting balls from the crossbar assembly (AA).

Fit the backplate on the xture body (A) to the crossbar assembly (AA) and secure with mounting balls.

*If this does not work, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled

hex nuts.

*Then, screw the mounting screws in or out of the crossbar assembly (AA) until the desired length is achieved.

*Once the backplate on the xture body (A) is secure, remove the mounting balls and xture body (A) and proceed to Step 3.

Mounting balls