Installation Guide

Installation (continued)
6
4
Installing the xture body to outlet box
□
□
Line up the holes on the canopy of the xture body (A) and the
mounting holes on the crossbar assembly (AA).
Secure with the mounting screws (DD). Tighten until snug.
AA
DD
A
A
Adjust each arm
□
5
Adjust each arm on the xture body (A) to your desired location.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
Design Solutions International Inc.
Model: DSHD19542F
Address: 6 Corporate Parkway Goose Creek SC 29445
Telephone: [phone]
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Any changes ions not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.