Installation Guide

□
□
Pre-Installation
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard.
Phillips
Screwdriver
Safety
Goggles
Electrical
Tape
Pliers Ladder
TOOLS REQUIRED (NOT INCLUDED)
HARDWARE INCLUDED
3
NOTE: Hardware not shown to actual size.
AA 1
BB
3
CC
Outlet box screw
Mounting screw
2
Wire connector
2
DD
(Pre-assembled to xture body)
Crossbar Assembly
(Pre-assembled to xture body)
Part Description Quantity
AA
BB CC DD
NOTE: The LED has been permanently installed in this
lamp. The LED does not need to be replaced. Do not
attempt to remove or replace the LED. Do not touch the
LED or electrical connection directly with hands.
IMPORTANT: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have occurred
during shipping. If there is a defect in the wire, do not
attempt installation. Please call Customer Service Team at
1-800-388-6141 ext 216. For customer service support
and the fastest response, please email us at
[e-mail].