Manualshelf

Use and Care Manual

ManualsBrandsDSI LIGHTING ManualsFlush Mount Ceiling LightsSolero 13 in. 3-Light Bronze and Antique Brass Flush Mount with Clear Shades
12345678
Installation
AA
AA
BB
CC
DD
EE
5
□ Screw the threaded tube (CC) into the mounting strip (AA), and
secure it using the lock washer (EE) and hex nut (DD).
□ Fasten the mounting strip (AA) onto the outlet box using two
outlet box screws (BB).
1
Preparing the mounting strip
3
Making the electrical connections
NOTE: The threaded tube (CC) should extend long
enough to protrude through the canopy, when it is
mounted. (Adjust as needed.)
GG
FF
AA
A
□ Strip 3/4 in. of insulation from the wire ends.
□ Connect the black wire from the xture to the black wire from the outlet box, then connect the white wire from the xture to the
white wire from the outlet box.
□ Connect the bare copper ground wire from the xture body (A) to the ground wire from the outlet box. The bare copper ground wire
from the canopy must loop one turn under the head of the green ground screw (FF) on the mounting strip (AA) before it is connected
to the ground conductor of the supply circuit.
□ Cover the wires with wire connectors (GG). Tape the wire connectors (GG) and wires together, and carefully position all wires inside
the outlet box.
2
Installing the mounting strip