Use and Care Manual

IMPORTANT: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have occurred
during shipping. If there is a defect in the wire, do not
attempt installation. Please call the Customer Service
Team at 1-800-388-6141 ext. 216. For customer
service and the fastest response, please email us at
[e-mail].
NOTE: This product requires three 60W maximum
medium base (E26) type "64" or type "A" bulbs or 9W
maximum medium base (E126) self-ballasted LED bulbs
(sold separately).
NOTE: Hardware not shown to actual size.
Pre-Installation
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard.
Phillips
Screwdriver
Safety
Goggles
Wire
Stripper
Electrical
Tape
Pliers
TOOLS REQUIRED (NOT INCLUDED)
HARDWARE INCLUDED
AA
BB
FFEE
CC
GG
HH
DD
3
Part Description Quantity
AA
Mounting strip
1
BB
Outlet box screw
2
CC
Threaded tube
1
DD
Hex nut
2
EE
Lock washer
1
FF
Green ground screw
(Pre-assembled to mounting strip (AA))
1
GG Wire connector 3
HH
Finial
1
Flathead
Screwdriver