Instructions / Assembly

Installation
AA
AA
BB
CC
DD
B
EE
A
5
□ Screw the threaded tube (CC) into the mounting strip (AA), and
secure it using the lock washer (EE) and hex nut (DD).
□ Fasten the mounting strip (AA) onto the outlet box using two
outlet box screws (BB).
□ Loosen the plastic screw (B) on the canopy assembly (A) by using a athead screwdriver (not included) and adjust the xture wire
to the desired length, then tighten the plastic screw (B) back into the hole as shown in diagram.
□ Repeat this step for the other socket assembles.
1
Preparing the mounting strip
3
Adjusting the hanging length
2
Installing the mounting strip
NOTE: The threaded tube (CC) should extend long
enough to protrude through the canopy, when it is
mounted. (Adjust as needed.)