Instructions / Assembly
Option 1 Option 2 Option 3
Option 7Option 4 Option 5 Option 6
Installation
AA
A
B
C
D
E
F
F
F
G
E
F
F
E
F
F
F
F
E
F
F
F
F
F
F
G
BB
CC
EE
DD
5
□ Fasten the mounting strip (AA) onto the outlet box using two
outlet box screws (BB).
□ Screw the threaded tube (G-1/2”) (CC) into the mounting strip
(AA), and secure it using the lock washer (EE) and hex nut
(DD).
□ Guide the xture wires through each tube as shown, and then tighten the tubes until secured as shown.
□ Unscrew the buttery nuts (A) and lock washer (B) from the threaded tube (G-3/8”) (D).
□ Guide the xture wires through the threaded tube (G-3/8”) (D), the canopy (C), the lock washer (B) and the buttery nut (A). Screw
the threaded tube (D) into the top of the tube (E), and then place the canopy (C) on the top of the threaded tube, secure with the
lock washers (B) and the buttery nuts (A).
□ There are seven height options for you to choose from:
1
Preparing the mounting strip
2
Attaching the canopy and the tubes to the xture body
NOTE: The threaded tube (G-1/2") (CC) should extend
long enough to protrude through the canopy (E) when it
is mounted. (Adjust as needed.)