Use and Care Manual

Installation
AA
AA
BB
CC
DD
HH
II
EE
KK
A
B
CC
5
□ Screw the threaded tube (CC) into the mounting strip (AA), and
secure it using the lock washer (EE) and hex nut (DD).
□ Fasten the mounting strip (AA) onto the outlet box using two
outlet box screws (BB).
□ Place the canopy (KK) over the threaded tube (CC), and screw
the screw collar loop (HH) onto the threaded tube (CC).
□ Secure the canopy (KK) using the ring (II).
□ Guide the xture wire with bare copper ground wire through the
loop (A), then screw the loop (A) onto the top of the xture body
(B) securely.
1
Preparing the mounting strip
3
Attaching the canopy to the outlet
box
4
Assembling the xture body
2
Installing the mounting strip
NOTE: The threaded tube (CC) should extend long
enough to protrude through the canopy, when it is
mounted. (Adjust as needed.)