Use and Care Manual

IMPORTANT: Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have occurred
during shipping. If there is a defect in the wire, do not
attempt installation. Please call the Customer Service
Team at 1-800-388-6141 ext. 216. For customer
service and the fastest response, please email us at
[e-mail].
NOTE: This product requires three 60W maximum
candelabra base (E12) type "B" bulb or 9W maximum
candelabra base (E12) self-ballasted LED bulb (sold
separately).
NOTE: Hardware not shown to actual size.
Pre-Installation
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard.
Phillips
Screwdriver
Safety
Goggles
Wire
Stripper
Electrical
Tape
Pliers
TOOLS REQUIRED (NOT INCLUDED)
HARDWARE INCLUDED
AA
BB
FF
EE
CC
GG HH
II JJ
KK LL
DD
3
Part Description Quantity
AA
Mounting strip
1
BB
Outlet box screw
2
CC
Threaded tube
1
DD
Hex nut
1
EE
Lock washer
1
FF
Green ground screw
(Pre-assembled to mounting strip (AA))
1
Part Description Quantity
GG Wire connector 3
HH Screw collar loop 1
II
Ring (Pre-assembled to screw collar loop (HH))
1
JJ Quick link 2
KK Canopy 1
LL Chain 1