Use and Care Manual

Installation (continued)
6
□ Strip 3/4 in. of insulation from the wire ends.
□ Connect the black wire from the xture to the black wire from the outlet box, then connect the white wire from the xture to the
white wire from the outlet box.
□ The bare copper ground wire from the xture must loop one turn under the head of the green ground screw (EE) on the mounting
bracket (AA) before it is connected to the ground conductor of the supply circuit.
□ Cover the wires with wire connectors (FF). Tape the wire connectors (FF) and wires together, and carefully position all wires inside
the outlet box.
□ Place the canopy assembly (A) over the outlet box, and ensure
the heads of the support screws (long) (CC) come through the
holes of the canopy assembly (A).
□ Tighten the cap nuts (GG) onto the protruding support screws
(long) (CC) on the mounting bracket (AA) until the canopy
assembly (A) is held rmly against the ceiling.
4
Making the electrical connections
5
Assembling the canopy assembly to
the outlet box
6
Installing the light bulbs
AA
A
D
GG
CC
AA
FF
EE
□ Install the light bulbs (not included) into the sockets. Use three
60-watt medium base (E26) type “A” bulbs (recommended).
NOTE: You can also use three 9W maximum medium
base (E26) self-ballasted LED bulbs (sold separately). Do
not exceed the recommended wattage.