Model # DS18937 USE AND CARE GUIDE 1-LIGHT WALL SCONCE Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Three (3) Year Warranty ............................................................. 2 What is Covered ........................................................................ 2 What is Not Covered ...................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. NOTE: This product requires one 60W maximum candelabra base (E12) type "B" bulb or 9W maximum candelabra base (E12) self-ballasted LED bulb (sold separately). IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping.
Pre-Installation (continued) PACKAGE CONTENTS A B Part Description Quantity A Glass shade 1 B Fixture body 1 4
Installation 1 2 Preparing the mounting bracket □□ Fasten the support screws (long) (CC) into the mounting bracket (AA), and secure it using the hex nuts (DD). Installing the mounting bracket □□ Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (short) (BB). NOTE: The support screws (long) (CC) should extend long enough to protrude through the canopy on the fixture body (B) when it is mounted. (Adjust as needed.
Installation (continued) 4 Assembling the canopy assembly to the outlet box □□ Place the fixture body (B) over the outlet box, and ensure the heads of the support screws (long) (CC) come through the holes of the fixture body (B). □□ Tighten the cap nuts (GG) onto the protruding support screws (long) (CC) on the mounting bracket (AA) until the fixture body (B) is held firmly against the wall.
Care and Cleaning □□ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully. □□ To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture. Troubleshooting Problem Possible Cause Solution The lights will not turn on. The bulb is burned out. The power is off. There is a faulty switch.
Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.
