Model # DS18933 USE AND CARE GUIDE 3-LIGHT VANITY Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Three (3) Year Warranty ............................................................. 2 What is Covered ........................................................................ 2 What is Not Covered ...................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. NOTE: This product requires three 60W maximum medium base (E26) type "ST64" or type "A" bulbs or 9W maximum medium base (E26) self-ballasted LED bulbs (sold separately). IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping.
Pre-Installation (continued) PACKAGE CONTENTS A B C Part A Description Quantity Socket ring (Pre-assembled to socket of the fixture body (C)) 3 B Glass shade 3 C Fixture body 1 4
Installation 1 2 Preparing the mounting bracket □□ Unscrew the four support screws (short) (CC) from the mounting bracket (AA). Remove the mounting bracket (AA) from the canopy of the fixture body (C) and keep the mounting bracket (AA) and four support screws (short) (CC) for later use. Installing the mounting bracket □□ Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (long) (BB). AA BB AA C CC 3 Making the electrical connections □□ Strip 3/4 in.
Installation (continued) 4 Assembling the fixture body to the outlet box □□ Place the fixture body (C) over the outlet box, align the four holes of the mounting bracket (AA) and the holes of the canopy of the fixture body (C), then tighten the support screws (short) (CC). □□ There are two installation options to choose from.
Care and Cleaning □□ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully. □□ To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture. Troubleshooting Problem Possible Cause Solution The lights will not turn on. The bulb is burned out. The power is off. There is a faulty switch.
Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.
