Model # DS18931 USE AND CARE GUIDE 4-LIGHT CHANDELIER Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Three (3) Year Warranty ............................................................. 2 What is Covered ........................................................................ 2 What is Not Covered ...................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping. If there is a defect in the wire, do not attempt installation. Please call the Customer Service Team at 1-800-388-6141 ext. 216.
Pre-Installation (continued) PACKAGE CONTENTS A B C C C E F D G Part Description Quantity Part E A Canopy assembly 1 B 6” tube 1 C 12” tube 3 D Large tube 1 4 Description Socket ring (Pre-assembled to fixture body (G)) Quantity 4 F Glass shade 4 G Fixture body 1
Installation 1 2 Preparing the mounting bracket □□ Fasten the support screws (long) (CC) into the mounting bracket (AA), and secure it using the hex nuts (DD). Installing the mounting bracket □□ Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (short) (BB). NOTE: The support screws (long) (CC) should extend long enough to protrude through the canopy assembly (A) when it is mounted. (Adjust as needed.
Installation (continued) 4 Making the electrical connections □□ Strip 3/4 in. of insulation from the wire ends. □□ Connect the black wire from the fixture to the black wire from the outlet box, then connect the white wire from the fixture to the white wire from the outlet box. □□ The bare copper ground wire from the fixture must loop one turn under the head of the green ground screw (EE) on the mounting bracket (AA) before it is connected to the ground conductor of the supply circuit.
Installation (continued) 7 Installing the light bulbs □□ Install the light bulbs (not included) into the sockets. Use four 60W maximum medium base (E26) type “ST64” bulbs (recommended). NOTE: You can also use four 60W maximum medium base (E26) type “A” bulbs or 9W maximum medium base (E26) self-ballasted LED bulbs (sold separately). Do not exceed the recommended wattage. G Care and Cleaning □□ Do not use any cleaners with chemicals, solvents, or harsh abrasives.
Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.
