Instruction manual

Accessing Your Security System

Local Access

To access your security system from a telephone on the same phone line as your security system:

1. Pick up the telephone. You will hear a dial tone.

2. Enter your [Telephone Access Code]. The dial tone will stop and the system will announce

'Hello'

3. Depending on how your system is set up, the system may announce

'Enter Your Access Code'

Enter your [Access Code].

4. You can now access system functions.

Remote Access (Not permitted on UL Listed systems)

To access your security system from outside the premises:

1. From a Touch-Tone telephone, call the security system and let the line ring once.

2. After a single ring, hang up and call again. On the second call, the system will pick up after one or two rings

and announce

'Hello'

3. Enter your [Telephone Access Code]. If you do not enter it within 10 seconds the system will hang up. The

system will then announce

'Enter Your Access Code'

4. Enter a valid [Access Code]. If you do not enter it within 20 seconds the system will hang up. The system will

also hang up if 3 incorrect access codes are entered.

Once a valid access code has been entered, the system will announce one or more messages to advise of the

status of the system.

S e c t i o n 3