Installation guide

PowerSeries - PC1616/PC1808/PC1832/PC1864

Section [023] Tenth System Option Code

Section [030] Fast Loop Response

This section is used to determine the Loop Response Time for the main panel zones.

Section [101] to [164] Zone Attributes

These sections are used to customize the operation of the zones. There are 9 toggle options in each Section:

[7] Future Use

[8] ON: When the system is armed in Stay mode, during the Exit delay, the system will sound 1 beep every 3 second.

OFF: When the system is armed in Stay mode, the system will be silent during the Exit delay.

Option Description

[1] ON: the keypad [F] emergency key will only beep three times to acknowledge the button has been pressed. The system will not

activate the bell output. OFF: the system will activate the bell output and beep the keypad.

[2] Refer to the PC1616/PC1832/PC1864 Reference Manual for 200 Baud Open/Close Identifier details.

[3] ON: the system will only transmit the Test Transmission reporting code if the system is armed at the time the system is programmed

to report the event. OFF: the system will always report the Test Transmission reporting code at the programmed time.

[4] ON: the system changes the Test Transmission Reporting Cycle Time from Days to Hours. OFF: the Test Transmission Reporting

Cycle Time is in Days.

[5] ON: the user cannot switch from Away Arm mode to Stay Arm mode using the function keys. OFF: the user can switch arming

modes.

[6] ON: the system disconnects a listen in/two-way session if a new event occurs.

OFF: the system does NOT disconnect. New events are transmitted only after the session is terminated.

[7] ON: the system does NOT activate the keypad buzzer for any trouble condition (excluding Fire Troubles). OFF: the system

annunciates troubles via the keypad buzzer (two beeps every 10 seconds) normally.

[8] ON: Keyswitches will always arm in away mode. OFF: Keyswitches will arm in away mode if an entry/exit zone is violated during

exit delay.

ON: the loop response time will be 36 mS. OFF: the loop response time will be 400 mS.

Option Description

[1] ON: alarms are audible (bell output). OFF: alarms are silent.

[2] ON: the bell output is steady (burglary). OFF: the alarm output pulses (fire).

[3] ON: a zone violation or restoral will activate Chime. OFF: Chime is not activated.

[4]

ON: the user can manually bypass the zone using the [

][1] command. OFF: the zone cannot be manually bypassed.

[5] ON: the partition can be armed even if the zone is violated (the zone will not affect the Ready status). OFF: the zone must be

secure before arming.

[6] ON: the system shuts down alarm reporting after the programmed number of alarms have occurred. OFF: the panel will always

report the event if an alarm occurs.

[7] ON: the system delays reporting the event for the time programmed for the Transmission Delay time. OFF: the panel

immediately transmits the reporting event when an alarm is detected.

[8] ON: the zone is a wireless or addressable device. OFF: the zone is a hardwire zone (main panel, zone expander or keypad zone).

[9] ON: the zone has the Cross Zone feature enabled. OFF: the zone functions normally.