Installation manual

How do I get Skyroute up and running?

Getting a Skyroute Transceiver ready to transmit signals back to your central station

is done by following three simple steps, which we refer to as the 5-5-5 process'. This

means that no more that five minutes is required for each step when performing a

standard installation. Here is the explanation of that procedure:

Installation: Simply take the Skyroute Transceiver out of the box and

remove the top right knockout of the control panel cabinet. Then slide

and clip the module in position, screw the antenna and wire the

module to the main control via 5 wires. If not using a tamper connected

to the Skyroute transceiver, place a piece of wire between the TMP and

COM terminals.

Programming: Enter programming mode as usual; access the Skyroute

Transceiver mode, enter your existing zone definition in sections 01-

04, your SID in section 07 and program the appropriate options in

sections 13 and 22 according to your service plan. You will find exactly

what to enter in the installation manual.

Activation: Call the Connect 24 activation phone number and enter the

information requested by the system: your profile number, installer ID,

PIN number, MIN number, SID number and account code.

Your Skyroute Transceiver is now ready to transmit!