Installation manual

4
Reader LED Flash Rates
Most access card readers will have an LED output to pro-
vide visual feedback when the access card is presented to
the reader. The light will flash in different ways to indicate
the following conditions:
Buzzer Operation
Most access card readers will have a buzzer output to pro-
vide audible feedback. The buzzer output may be con-
nected to operate local warning devices for the following
conditions:
• The access-controlled door has been forced open. The
buzzer will activate and remain active until the door has
been closed.
• The access-controlled door has been left open too long.
The buzzer will activate and remain active until the door
has been closed. The buzzer will pulse on and off for the
last half of the programmed Door Open Time to indicate
that the Door Open Too Long event is about to occur.
*Tamper conenction not available on the MiniProx detector.
LED State Access Condition
Steady Red Door is locked
Steady Green
Door is unlocked
-
Access
Granted
Slow flash (state changes
every half second
The partition that the
Arm/Disarm mask is
assigned to is armed
Medium Flash (state changes
3 times/second
Waiting for a Privileged
card to be presented
LED State Access Condition
Fast flash (state changes 4
times/second
Access denied/Time
expired waiting for a privi-
leged card.
PC4820 Connection Chart
Reader Connection
Function PC4820 Terminal
Polaris/ShadowProx/IoProx HID
Green Green Data 0 GRN
White White Data 1 WHT
Red Red +VDC or +12VDC +5V or +12V
Black Black Ground GND
Blue Yellow Buzzer Buzz
Brown Brown (Red LED) LED LED
Orange/Yellow
(Polaris only)
Terminals marked as Tamper
Common & Tamper Select*
Tamper Switch
To PC4010/4020 zone or con-
nected in series with the
assigned door input on this
module (optional)
------- Blue Hold Not used
------- Orange Green LED Not used
------- Violet Return GND
Purple/Grey (POL-2KP only) ------- Independent Switch
Can be used for Arm or Post
inputs. See PC4820 Wiring Dia-
gram for instructions
PC4820 List of Supported Readers and Cards
Reader Type Reader Part Numbers Supply Voltage Card Part Numbers Format
Magnetic Stripe POL-1, POL-1W, POL-2, POL-2KP
+5VDC POL-C1CN 00 Polaris
Bar Code BC-201
Proximity:
ShadowProx
SH-1, SH-2, SH-2KP +5V
DC to 14VDC
SH-C1, SK-K1, SH-CMG1, SH-
CMG2 01-KSFSH-4, SH-5 +12V
DC
SH-6, SH-7 +24VDC TO 28VDC
HID
HID-MP5365 - MiniProx +12V
DC
HID-13666KSF, HID1336KSF,
HID-1386KSF, HID-1326KSF,
HID-1346KSF
02 - 26 Bit Wiegand
HID-PR5355, HID-PR5355KP -Prox-Pro
HID-MX5375 - MaxiProx
+10V
DC to 15VDC
+14
VDC to 28.5 VDC
IoProx P-100, 200, 300, 400 (all XSF/W26) +5VDC to 14VDC
P10SHL, P20DYE
P30DMG, P40KEY
02-W26
07-XSF