Installation manual

FCC COMPLIANCE STATEMENT

CAUTION: Changes or modifications not expressly approved by Digital

Security Controls Ltd. could void your authority to use this equipment.

This equipment generates and uses radio frequency energy and if not

installed and used properly, in strict accordance with the manufacturer’s

instructions, may cause interference to radio and television reception. It has

been type tested and found to comply with the limits for Class B device in

accordance with the specifications in Subpart “B” of Part 15 of FCC Rules,

which are designed to provide reasonable protection against such interfer-

ence in any residential installation. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does

cause interference to television or radio reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

• Re-orient the receiving antenna

• Relocate the alarm control with respect to the receiver

• Move the alarm control away from the receiver

• Connect the alarm control into a different outlet so that alarm control and

receiver are on different circuits.

If necessary, the user should consult the dealer or an experienced radio/tele-

vision technician for additional suggestions. The user may find the follow-

ing booklet prepared by the FCC helpful: “How to Identify and Resolve

Radio/Television Interference Problems”. This booklet is available from the

U.S. Government Printing Office, Washington, D.C. 20402, Stock # 004-

000-00345-4.

Toronto, Canada • www.dsc.com

Tech. Support: 1-800-387-3630 (Canada & U.S.) or 905-760-3036

Printed in Canada

29005940R003