INSTRUCTION MANUAL PC255O
Canadian Department of Communications Notice SYSTEM REFERENCE NOTICE: The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction.
A WORD ABOUT YOUR SYSTEM MASTER CODE The PC2550 Security System has been designed to give you the greatest possible flexibility and convenience. Read this manual carefully and become familiar with the operation of your Security System. Your installer will tell you which commands listed in this manual apply to your system. Fill out the SYSTEM REFERENCE sheet in this manual and store it in a safe place for future reference.
DISARMING TROUBLE DISPLAY Enter the premises only through the door indicated by your installer as the entry/exit door. The keypad sounder will be ON. Go to the keypad and enter the [4 digit access code]. If an error is made entering the code, press the [#] key and enter the code again. The “Armed” light will go out and the keypad sounder will stop. A correct access code must be entered before the allowed entry time expires. The entry delay time may be changed by the installer.
IMPORTANT Test system weekly, have system trouble conditions corrected by installer. Zone Lights, when ON in the normal operating mode, indicate an open zone. eg. open door, window, etc. Refer to zone chart on keypad door for zone information. Fire light is ON when a detector on the fire loop is in alarm. Press any key within 30 seconds of first alarm to get 2 minutes to reset smoke detectors. Ready light ON: system ready for arming. Ready light OFF: open zone; must be closed or bypassed before arming.
PROGRAMMING ADDITIONAL ACCESS CODES ALARM TEST Up to 15 access codes in addition to the Master Code can be entered from the keypad. Enter [ ][6][Master Code][8] for a 2 second test of the keypad lights, keypad sounder and alarm bells. ∗ Enter [ ][5][Master Code]. The “Program” light will flash and the zone lights will show which of codes 1 to 8 have already been programmed. To enter a new code or change an existing code, first press the code number (1 to 8) and then enter your [4 digit] code.
TESTING FAMILY ESCAPE PLANNING IT IS RECOMMENDED THAT THE SYSTEM BE TESTED ON A WEEKLY BASIS Note: Perform such activities in the off-peak hours, such as early morning or late evening. There is often very little time between the detection of a fire and the time it becomes deadly. It is thus very important that a family escape plan be developed and rehearsed. 1. Inform the monitoring station that you are testing your system. 1. Every family member should participate in developing the escape plan. 2.
LIMITED WARRANTY Digital Security Controls Ltd. warrants that for a period of twelve months from the date of purchase, the product shall be free from defects in materials and workmanship under normal use and that in fulfilment of any breech of such warranty, Digital Security Controls Ltd. shall, at its option, repair or replace the defective equipment upon return of the equipment to its repair depot.
