Installation manual

This section describes how to enroll and program:

• wireless devices using zones (WLS904, WLS905, WLS906, WLS907 and

WLS908)

• wireless keys (WLS909)

• handheld keypads (WLS910).

For more information on these devices, read the instruction sheet included with

each device.

3.1 A Note about Electronic Serial Numbers

An electronic serial number (ESN) is printed on the back of each wireless device.

ESNs are used to enroll the wireless devices with the PC5132-RS receiver.

In order to reduce the occurrence of wireless devices with the same serial

number, 6-digit serial numbers are now printed on the back of each wireless

device.

NOTE: 6-digit serial numbers are only supported on the following control pan-

els: PC5010 v2.x and higher, PC1555 and PC580.

The 6-digit serial numbers include hexadecimal digits. For instructions on

programming hexadecimal numbers, see your system Installation Manual,

section 4: How to Program.

When connecting the PC5132-RS to a PC5010 v1.x panel, enter 5-digit serial

numbers only. When connecting the PC5132-RS to a PC5010 v2.x and higher,

PC1555 or PC580 panel follow the instructions below.

New Wireless Device ESNs

All new devices have both a 5-digit and a 6-digit serial number printed on them

so that they can be used with all versions of the PC5132-RS wireless receiver.

When enrolling devices with the PC5132-RS:

For PC5132-RS v2.x and lower: enter the 5-digit ESN

For PC5132-RS v3.0 and higher: enter the 6-digit ESN

Old Wireless Device ESNs

You can use older devices on all versions of the PC5132-RS receiver, even

though they only have a 5-digit ESN. When using older wireless devices:

For PC5132-RS v2.x and lower: enter the 5-digit ESN

For PC5132-RS v3.0 and higher: enter [0] + 5-digit ESN

S E C T I O N 3

Enroll & Program Devices