Specifications

[62] Third User Display Mask
Default Option ON OFF
ON
I_______I 1 System Test prompt ON System Test prompt OFF
ON
I_______I 2 Time and Date prompt ON Time and Date prompt OFF
ON
I_______I 3 Auto-Arm Control prompt ON Auto-Arm Control promptOFF
ON
I_______I 4 Auto-Arm Time prompt ON Auto-Arm Time prompt OFF
ON
I_______I 5 Download Enable prompt ON Download Enable prompt OFF
ON
I_______I 6 Bright Control prompt ON Bright Control prompt OFF
ON
I_______I 7 Contrast Control prompt ON Contrast Control prompt OFF
ON
I_______I 8 Buzzer Control prompt ON Buzzer Control prompt OFF
[63] Downloaded LCD Message Duration
Default
003
I______I______I______I (Valid entries are 000-255, 000=Unlimited Message Display. This number represents the number of times
the Downloaded message is cleared by pressing any key while the message is up after timeout)
[64] Key Options
Default Option ON OFF
ON
I_______I 1 [F]ire Keys enabled [F]ire Keys disabled
ON
I_______I 2 [A]uxiliary Keys enabled [A]uxiliary Keys disabled
ON
I_______I 3 [P]anic Keys enabled [P]anic Keys disabled
OFF
I_______I 4-8 For Future Use
[65] Fourth User Display Mask
Default Option ON OFF
ON
I_______I 1 User Initiated Call-up Prompt ON User Initiated Call-up Prompt OFF
ON
I_______I 2 Last Code to Disarm/Arm Prompt ON Last Code to Disarm/Arm Prompt OFF
ON I_______I 3 Walk Test Prompt ON Walk Test prompt OFF
[66] Keypad Options
Default Option ON OFF
ON I_______I 1 Display Access Code when Programming Display ‘X’ when Programming
ON I_______I 2 Local Clock Display Enabled Local Clock Display Disabled
OFF I_______I 3-8 For Future Use
[97] View Software Version
[98] Initiate Global Label Broadcast
All LCD programming is done per keypad. If more than one LCD keypad are present on the system, labels programmed at one
keypad can be broadcast to all other LCD keypads. Perform the following procedure in order to broadcast labels:
Step 1 - Program one LCD keypad completely.
Step 2 - Make sure all LCD keypads are connected to the KEYBUS.
Step 3 - Enter Installer’s Programming, then enter Section [98] at the keypad that was programmed. The keypad will now broadcast
all the information programmed to all the other LCD keypads on the system.
Step 4 - When the keypad is finished press the [#] key to exit.
[99] Reset LCD EEPROM to Factory Defaults
032
064 176
240
033
225
241
034
035
036
228
244
038
230
246
039
231
040
248
041
249
042
058
234
043
059
123
044
060
124
236
045
061
093
125
253
046
062
094
126
238
047 063
095
127
239
255
254
ASCII CHARACTERS
Appendix C