User Manual

00 00
:
00 0000 00
SESSION
STOPSUM UP-TALKTALK
START
TOTAL TIME
0:00
Options: Beep - Blink
Connect Signal Light to Limitimer with Cat-5 cable
or Cat-5–to–XLR adapter KES 882 (included).
Plug in 12 V power supply (A).
Turn on power switch (B).
Program 1 is the default program.
Note: Blink and beep settings, like time settings,
are set for each program individually.
Blink: Red light starts to blink after it comes on
Beep: Audible cue is sounded on yellow-to-red
light and on red blink
Blink + Beep: Audible cue is sounded on yellow-
to-red change, then, once every other second
when Red light starts to blink.
Note: Hold Beep button to activate a single
manual beep.
Set Total Time
Set Sum-up Time
Press Start.
(A) (B)
Quick Start - Set-up
PSL-PB6
Programs are useful for debates or contests
where pre-set timing formats can be selected
quickly or where timekeeping is separate for each
speaker.
Programs 1, 2, and 3 cannot run simultaneous
with each other. Toggling between these programs
stops the clock. Session 4 is a program that can
run in background to Program 1, 2 or 3.
A dimly-lit Program LED indicates that a program
is running in background. A brightly lit LED
indicates that the program is selected. A signal
light set to display multiple programs displays the
program selected on the timer.
Up to 3 signal lights (PSL-20V or ASL2-ND3) can
be powered from the base timer at a distance of
about 200-feet. Longer distances will produce
power attenuation due to resistance in the cable.
To drive additional lights at greater distances, use
DSan model PSL-PB6 or PSL=PB18 power
distribution hubs with a a appropriate power
supply
To pre-set a
program, select that
program.
Set Total Time,
Sum-up Time, Blink
and Beep.
These settings are
saved for the
selected program.
PROGRAMS
1
2
3
4
SESSION
STOP
STOP
CONTINUE
CLOCK
INDICATOR
Multiple Signal Lights
Using the Programs