Operation Manual
23
Warning: ONLY add water.
Do not use any cleaners or other liquids.
4. Using the funnel and the measuring beaker, ll no more than 650 ml water into
the ll spout.
5. In order to seal the ll spout, turn the safety lid around clockwise
approx. 6 times. The resistance will then increase. Continue to turn the cover
while now holding it down. Turn it until the safety lid has been tightly sealed.
Connecting and using the unit
Never point the vapour stream in the direction of persons or
animals! Danger of scalding! Never direct the steam on people and
animals. Never direct the steam on electric devices or
attachements.
1. Connect the mains plug to an easily accessible socket.
2. Mount the desired adapter on the unit.
3. Set the red On/Off switch on the unit to “I”. The control
light on the switch will illuminate in red, unit‘s control light
(arrow Fig.) will illuminate in yellow.
4. Wait min. 3 minutes until the unit has warmed up.
5. Press the steam trigger (Fig.). Steam will be emitted from
the selected adapter. Release the steam trigger if you wish
to stop steam from being emitted. Move the device over
the surface to be cleaned. When trying out the device
for the rst time, do so in an inconspicuous area. Should
you be unsure as to whether you should clean a surface
with this steam cleaner, consult a professional before
doing so.
Attention: If you do not use the unit for longer times, the steam in the hose
may condense. When you use the unit after a longer time water may drop
out.
6. If you would like to turn off the unit, set the red On/Off switch to “O”.
7. If you wish to change the adapter during use, press the “O” button on the On/Off
switch in order to deactivate the unit. Disconnect the mains plug from the socket
and allow the unit to cool off completely before changing the adapter.
8. Remove the mains plug from the socket after every use!