Operation Manual

16
3. Fill the water tank with the help of the filling cup with no
more than 400 ccm water.
4. Replace the dial on the fill opening and turn to the „locked
lock“ symbol in order to securely close the water tank.
5. Connect the device to a properly installed socket.
6. Push the On/Off switch to ON in order to turn on the
device.
The device will heat up and then after approximately 30 seconds, start emitting
steam out of the nozzle adapter.
7. Move the device over the surface to be cleaned. When trying out the device
for the first time, do so in an inconspicuous area. In the event you are unsure
as to whether you should clean the surface with this steam cleaner, consult a
professional before doing so.
8. If you would like to turn of the unit, push the On/Off switch to OFF.
Refilling the steam cleaner with water
• Only refill the steam cleaner with water once the tank has been
completely used up and no more steam is emitted and the device has
completely cooled off.
• In order to prevent calcification of the device in advance, we recommend
that you use distilled water. However, the steam cleaner can also be used
with normal tap water. The warranty and guarantee do not cover
damages that are caused by calcification.
1. Push the On/Off switch to OFF. The device has been turned off.
2. Allow it to completely cool off and pull the cord out of the socket.
3. Open the water tank as described under “Using the device“ and fill it using the
filling cup in the tank.
4. Carefully reseal the water tank.
5. Connect the cord to the socket and push the On/Off switch to ON in order to
turn on the device.