Operation Manual

Start-up

• Remove the device from the packaging and check if all components are present.

If this is not the case, contact our customer service centre.

Selection an adapter

Nozzle adapter

Use the nozzle adapter e.g. if you wish to clean tile joints or difﬁ cult

to reach areas.

For this, mount the adapter to the front of the steam cleaner.

The resting tips on the adapter must extend into the slots on the

front of the device. Then turn the adapter in the direction of the

arrow in order to lock it into place. The steam emitting opening on

the nozzle adapter must then point down as shown.

If needed, you can also mount a brush on the nozzle adapter.

Brush adapters

Two brushes are included with the steam cleaner. A soft brush for

small amounts of dirt and a hard brush for difﬁ cult to remove dirt.

Simply mount the desired brush on the nozzle adapter as shown

ensuring that it locks into place.

Squeegee

The squeegee can be used for cleaning glass surfaces. Simply mount

the squeegee on its respective handle as shown.

Using the device

When trying out the device for the ﬁ rst time, do so in an inconspicuous

area. If you are uncertain as to whether the surface could be damaged by

the steam, please consult a professional.

1. Unwrap the cord completely from the cord winder.

2. Turn the dial on the water tank ﬁ ll opening in the

direction of the arrow to the „unlocked lock“ symbol and

remove the dial.