User Manual

Modulator settings
All of the 8 Modulators have the same settings.
Use the Speed control to define the actual time period for each of the 32 steps used for envelope
generation. The value field below the Speed knob provides a popup menu which can be useful
for quick selection of a setting. The Sync switch defines whether the generated envelopes are
temposynced (ON) or free-running (OFF).
Each Modulator has two built-in modules, Tremolo and Pan Flip. The Tremolo modulates the output
volume by the generated envelope, while the Pan Flip modulates the output panning. These modules
can be used for creating tremolo/trance-gate and auto-panning eects respectively. The
Tremolo and Pan Flip controls define the amount of modulation applied. Modulations form dierent
modulators are summed. This allows you to create complex tremolo and pan flip eects. There also is
a Tremolo and Pan Flip Destination control:
The control requires some additional explanations. As you will see in the Layer Eects section, each
layer provides serial chain of 6 eects, which process the incoming audio. The Tremolo and Pan Flip
modules can be treated as a 7th layer eect, which can be inserted into dierent positions
of the processing path depending on the Destination control setting. When «G» («Global») setting
is selected, the Tremolo and Pan Flip modules are inserted at the output of the Layer Mixer, after
summing the audio output of both layers. The «G» setting is useful to process the output of both
layers with the same Tremolo and Pan Flip. In this mode, the position of the “TREM” module of the
Routing control located in the Top Bar section does not aect the processing path order.
The Tremolo and Pan Flip modules can be inserted into the serial chain of the Layer as well. You can
use«A» and«B» setting to insert the modules into the Layer A and B respectively. In both cases, the
position of the “TREM” module of the Routing control defines the actual position of the modules in
the serial processing chain of each layer.
Thus the actual number of the modules in the serial chains of the Layer A and B depends on the value
of the Destination control. The serial chains contain the additional Tremolo and Pan Flip modules
when «A» or «B» setting is selected. However the Tremolo and Pan Flip modules are removed from
the serial chains when «G» mode is active.
20