User Manual

Distortion
The module oers a high quality multi-stage circuit-modelled distortion
The Drive knob controls the amount of amplification of the incoming signal
before it enters the distortion stages.
Before transforming audio at the main distortion stage it is preprocessed in
a special Fuzz stage, which provides a model of a classic analog fuzz pedal.
With the Fuzz control you can adjust the amount of pre-distortion, which results
in altering the high frequency contents.
After the Fuzz section signal enters the main distortion stage. The Dist Type
selector allows you to choose one of four dierent distortion simulation modes,
which used for processing in the main stage.
You can use the Mono knob to narrow the output stereo image. When the
knob is turned fully to the right the output signal has identical left and right
channels.
The output of the distortion stage is processed by the Tone section, which
actually consist of a specialized filter chain intended for the simulation of tonal
changes inside analog comb amplifiers Use the Tone control to alter the color
of the output sound.
Finally, the Output control allows to adjust the output volume of the signal.
14