User Manual
The Layer Eects Section
The Layer Eects section is the main audio processing part, which process audio and in response to
the applied modulations form rhythmic pulsations in your sounds.
Tantra provides 2 groups of 6 high quality processing eects. The groups are called Layer A and B.
You can switch between Layers by using the Layer selector, located in the Top Bar section:
The Master Section contains several layer controls:
Layer A and B are organized as two independent stereo channels. Each layer has output Level, Pan
and Bypass controls, that allow you to adjust position and volume of layers in the output mix.
With the Routing switch you can choose one of two available processing modes:
• Serial configuration, where the output of Layer A is connected to the input of Layer B
• Parallel configuration, when you would like to process input audio by two independent
channels and mix their output
Please note, in Serial mode, the output of Layer A is additionally sent to the output of the section.
In Serial mode Level A and Pan A control the amount and position in the mix of the output of Layer
A that is sent to the section output. If the power switch of the Layer A is turned o then Layer A still
provides the input signal for the Layer B, but the output of Layer A is not sent to the section output.
11