Instruction Manual

9
10
Safety Precautions
Notes
Please be sure to follow the instructions.
Please read "Safety Precautions" carefully before use and use the product correctly.
The precautions described in this instruction manual are intended to ensure safe and proper
use of the product and to prevent injury or damage to you or others.
If the product is used under abnormal conditions such
as smoke, strange smells or noises, it may cause fire
or electric shock.
If you notice a strange smell or smoke, turn off the
power of the device immediately and remove the
batteries.
After that, confirm that smoke is no longer emitted,
and contact the dealer for repair.
This unit is designed for indoor use only.
Be careful not to allow water to enter or wet the unit.
Doing so may cause malfunction, fire, or electric shock.
Do not place flower vases, flowerpots, cups, containers
filled with cosmetic chemicals or water, or small metal
objects near the device.If water gets into the equip-
ment, it may cause malfunction, fire or electric shock.
If foreign matter should enter the inside of the instru-
ment, first turn off the power and contact the dealer.
Do not place the product on an unstable place such as
on a wobbly stand, on a tilt, or near the edge of a
stand. Falling may cause injury.
Installation Notes
Location
Battery
Do not place the product in a humid or dusty place.
It may cause malfunction, fire, or electric shock.
Be sure to insert batteries in the correct orientation.
Inserting the battery in the wrong direction may cause
a malfunction, fire, or electric shock.
Installation Location
Do not install in the following locations
In places exposed to direct sunlight or close to heaters or other heat-emitting equipment.
Places with poor ventilation, high humidity, or high dust content.
Unstable places with vibration or inclination.
Places where the product may be exposed to rain or water.
Other places where the temperature is particularly high.
Places where there is a high risk of falling.
Batteries
Please use AA batteries. Other batteries cannot be used.
Please contact to your dealer or DS Audio distributor when repair is needed.
Limitations of Measurement and Adjustment
Repair
Expansion of record hole
No impact
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
Keep away from
water/moisture
No liquid nearby
Do not operate
this equipment
when it is broken
Do not make any
changes or
modification
Do not shake, bump, or otherwise subject the unit to
shock.
Such actions may cause malfunction.
Caution
Warning
Do not put things
inside.
Depending on the condition of the record disc, it may not be possible to measure correctly.
(End groove position deviates significantly from the record standard, color record
Label is close to the end groove,Sound groove is close to the end groove, etc)
If the warp of the record disc is too large, accurate measurement may not be possible.because
the stabilizer is shaken too much).
If the record hole is not centered correctly or the adjustment width (gap between the spindle
and record hole) is too small, the eccentricity may not be fully resolved.
Since this product is a manual adjustment of the record position by the customer, there is a
limit to the adjustment.
Once record holes are expanded, they cannot be restored.
Therefore, it is the customer's responsibility to expand the record hole using a reamer.